Cruiser's latest activity

Stripping is moving along pretty well .... This is a pic of the last strip before I remove the Bow support piece and a closeup of...

Allan pointed out to me last build that mixing strip widths is a valid method and I agree with that, if you are already at the "buckle"...

I hate to suggest this, but I suspect if you try cutting a few strips in half and try those, the problem will disappear. Those look...

The Jimmie clamps are like an extra hand, I use them to hold the strip in place, while I work clamping strips to the forms. . I still...

I think I mentioned this before as well, the 1/4" B&C is fine... to a point, then they start to kick out of the cove because it is...

I'm now radioactive (they actually gave me a wallet card & warned me that airports & tunnels could detect me... What the Hell did I...

You can never have too many

Great progress. Personally, I like to use more Jimmi Clamps .... my form spacings are ~`13.5" and I use 3 JCs between forms. In the...

I saw Jim post those, I always wondered (FB isn't great for build threads) if they adjusted or just apply more and more pressure as the...

Stripping Part 2a The strip hold down solutions, for stapleless stripper builds is literally a "Wild West" scenario with all sorts of...

Thanks Jim, on a side note about stemless, specifically the interlocking method. I figured out how a lot of it worked, but several...

Stripping Part 1 Since this is a staple less build, some of the clamping solutions need to get creative. Whenever there is a concave...

Did you check the Tabs along the bottom TheStripper? They are all there when I click the link

Yup, I mentioned that Station 1 correction value specifically under the Materials Required Section, didn't find that Station 0...

Guess I have a simpler view of tariffs in general. There is only one entity that pays directly and that is the consumer (assuming...