Kliff

Hate to point this out Cruiser, but: You may have Travis beat on Jimmy Clamps, but his shop is impressive! Yours is still neater than...

Instead of bugee cord, I used rubber roofing cut to 1" wide strips, bike tubes, and movers straps, which are like large rubber bands...

Thestripper: One BIG question: Are you going to cut the forms using a CNC router or laser where you need a CAD file? If you're...

LOL Jim! You're not helping. It looks to me like your points aren't in the proper order. My suggestion, look at two sheets in the...

Yes, the first sheet that shows when you open the link is only temporary data that gets exported to CAD. I'm most familiar with...

Oh, and regarding getting confused on the formatting of numbers from table of offsets. I consider myself pretty good at math, can...

Here's the spreadsheet I created...

Travis: I almost always make my own feather boards. I have a half dozen store bought, but I still make my own. By changing the length...

Cruiser: I also "lofted" from table of offsets, but I created a spreadsheet to convert it to X-Y coordinates that put them in the...