Roybrew

Raven has been moved to the back burner (well, actually the off-loading table of the shaper) and I finished putting the coves on the...

Strip Prep - taking place late fall 2023 Sorted through all of my left over strips and strip lumber, figure I have enough on hand for...

Solo on the Light Side Over the past couple of months, I noticed something about the canoe lookingfor/purchase/release threads that I...

I only had blow outs on a few of the strips, and it didn't seem to help by changing the feed rate. And all the router bits are new, so i...

Thanks guys. I opted for "tried & true" and loaded more strips into the soaking tubes tonight. I'll bend them in the jigs on Saturday...

Well, the weekend was a fiasco but I did manage a few hours in the shop. It took me about 3 hours to wet out the inside and I'm still...

OK, I spent the better part of today in the canoe shop. More and more, I'm liking the idea of making the seat removable and I looked at...

I've been making some headway but went over to the shop last night & screwed up the seat. Since last check-in, I made paper patterns...

Lofting Canoe Molds from CanoeCraft tables Preamble, Preamble ... I was going to use a BearMountain post I made, to answer a question...

Thank you Cruiser for explaining that. I've looked at the lofting measurements in Canoecraft several times, and struggled a little...

I had no idea what a location dot is, much less how to share one, so I had to look it all up. For android phones, the Google Maps app is...

Thanks Johan for the seat truss template, these turned out great.

Gamma, it may be easier to install rails for the seat to sit on, than trying to match the hull. With those in place, you could just add...

Didn’t get around to building a second canoe this winter. So decided to make a wannigan/cooler with some left over strips. Not done yet...

Nobody else in the woods, just me and the sounds of ice